中文  English
 Navigation
Product | Products

High temperature resistant conveyor belt

fabric specs

ep80 - ep - 630 cc - 56 t.c-56   width (mm) 300 - 200

The belt core with high modulus and low shrinkage, tensile strength high polyester canvas, plastic cover use high temperature resistant performance is good ternary ethylene propylene rubber or oxidation of butyl rubber, and with full resistance to high temperature materials for molding compound is delicate, vulcanization process and.

The product with the core after and special impregnation and setting treatment, bonding strength is very high, in 180 degrees Celsius below normal use conditions, elongation deformation small wear performance is excellent. In a short period of time can withstand 250 degrees Celsius temperature. Applicable to cement, coking, metallurgy, steel and other industrial use.

High temperature resistant conveyor belt

Uses: mainly used in metallurgy, construction and other industries, transportation of high temperature materials, such as sinter, coke, cement clinker, material temperature is not more than 800, with a surface temperature not exceeding 220. Features: the use of EPDM rubber cover, skeleton materials by domestic special resistance to high temperature canvas, unique recipe design, solved for ethylene propylene rubber high saturation and poor adhesion and adhesion between the layers is low key. With a light, long life (about 2-4 times), heat resistance of good characteristics.

Selection of heat resistance (high temperature) conveyor belt, product use note:

1, the selection of heat resistant conveyor belt:

According to the heat transfer belt, the temperature, surface structure and viscosity of the material are chosen to select the type of heat resistance. Such as sintering ore, coke and other bulk materials, such as the delivery temperature of 150 degrees, and the material and the surface contact area is relatively small, with the surface temperature maintained at 80 - 60, when the material with smaller viscosity of cement powder, the material temperature and the surface temperature difference is very small.

The surface temperature is closely related to the service life of the tropics. Directly affect the core layer, core layer glue and adhesive strength, cover rubber cover wear resistance, cracking resistance etc.. In the full investigation, measurement of surface temperature and other conditions, select the type of heat resistance.

Thick covering is an important condition for ensuring the long service life of the belt. Recommended for tropical cap thickness 6 - 9mm, 2 - 4mm.

2, the use of heat transfer belt:

The surface temperature of the whole strip must be measured, recorded and monitored continuously and continuously, and the temperature rise is not necessary;

The forced cooling of the adhesive tape for the material (preferably in the composite layer);

Keep the material to be distributed according to the bandwidth;

To prevent oil from being in the presence of (cooling water in the trace oil) to carry the damage over the heat itself;

The belt, which is equipped with thermal material, should be promptly taken to remove heat from the operation;

Heat resistance of the joints of the tropics is best to use hot glue.

 

 

BACK:Metal mesh core conveyor belt NEXT:Block edge
首页 产品展示 公司新闻 公司简介 技术设备 联系我们
COPYRIGHT ⓒ 山东盛润胶带有限公司 鲁ICP备14034599号  技术支持:奥讯软件